广东好彩1开奖结果167期 www.sadaig.com.cn
E1?;ぃ何低掣哐貢;?。當連續3s檢測到高壓?;な?,關閉除燈箱外的其他負載,屏蔽所有按鍵及??匭藕?,指示燈閃爍并顯示故障代碼E1.。E2?;ぃ何夷詵藍辰岜;?。在制冷、抽濕模式下,壓縮機起動6min,連續3min檢測到T蒸<-5℃時,指示燈閃爍并顯示故障代碼E2,停壓縮機、外風機;當T蒸>6℃,且壓縮機已停足3min時,指示燈滅,液晶恢復顯示,原狀態運行。不屏蔽按鍵。
E1 protection: High voltage protection for the system. When high voltage protection is detected for 3 seconds in a row, the load except the light box is turned off, all keys and remote control signals are shielded, and the indicator flashes and the fault code E1 is displayed. E2 protection: for indoor anti-freezing protection. In the mode of refrigeration and dehumidification, when the compressor starts for 6 minutes and detects T steaming <-5 degrees C for 3 minutes, the indicator flashes and displays the fault code E2, stops the compressor and the external fan; when T steaming > 6 degrees C and the compressor has stopped for 3 minutes, the indicator lights go out and the liquid crystal resumes to show the original state of operation. No shielding buttons.
E3?;ぃ何低車脫貢;?。壓縮機起動3min后開始檢測低壓開關信號,若連續3min檢測到低壓開關斷開,則整機停,指示燈閃爍并顯示故障代碼E3,以提示漏氟。E4?;ぃ何牌芨呶鹵;?。壓縮機起動后,連續30s檢測到排氣溫度高于120℃或排氣感溫頭短路(或開路)時,指示燈閃爍并顯示故障代碼E4。
E3 protection: low voltage protection for the system. The low-voltage switch signal is detected after the compressor starts for 3 minutes. If the low-voltage switch is disconnected for 3 minutes, the whole machine will stop. The indicator flashes and the fault code E3 is displayed to indicate the leakage of fluorine. E4 protection: high temperature protection for exhaust pipe. After starting the compressor, the indicator flashes and the fault code E4 is displayed when the exhaust temperature is higher than 120 C or the short circuit (or open circuit) of the exhaust temperature sensor is detected for 30 seconds.
E5?;ぃ何偷繆貢;?。壓縮機運轉后,若連續3s檢測到電流超過25A,指示燈閃爍并顯示故障代碼E5。EH?;ぃ旱緙尤裙收?。發出“BB”報警聲,紅燈閃。當環溫>35℃時,強制進入制冷。故障原因如下:交流接觸器內部粘連,須更換交流接觸器。熔斷器工作不正常,須更換熔斷器。
E5 Protection: Low Voltage Protection. After the compressor is running, if the current exceeds 25A for 3 seconds, the indicator flashes and the fault code E5 is displayed. EH protection: electrical heating failure. Send out the "BB" alarm sound and the red light flashes. When the annular temperature is higher than 35 C, it is forced to enter the refrigeration. The reasons for the failure are as follows: AC contactor internal adhesion, AC contactor must be replaced. If the fuse is not working properly, the fuse must be replaced.
春普广东好彩1开奖结果167期中央從事广东好彩1开奖结果167期,广东好彩1开奖结果167期,广东好彩1开奖结果167期,广东好彩1开奖结果167期
官方網站:广东好彩1开奖结果167期
最新內容:
|